unflooding procedure for 5.4 triton motor, F250
DVDr
12-12-2007, 11:01 AM
Hello,
Is it normal for these motors to flood ?
And what do you guys do to unflood them.
assuming the standard.
plugs, oil .
Is there any tricks ( example, pulling injector fuse so they dont fire and cranking , etc etc )
Thanks Alot
Is it normal for these motors to flood ?
And what do you guys do to unflood them.
assuming the standard.
plugs, oil .
Is there any tricks ( example, pulling injector fuse so they dont fire and cranking , etc etc )
Thanks Alot
Turbokid15
12-12-2007, 06:17 PM
The only thing i could think would be to pull the fuel pump fuse. Then crank until all unburt fuel is burnt. Put fuse back in prime then try to restart.
knelleken
12-12-2007, 08:12 PM
floor it why you crank the engine, the pcm will cut the injectors and clear the cylinders.
DVDr
12-13-2007, 12:21 PM
floor it why you crank the engine, the pcm will cut the injectors and clear the cylinders.
Ill try this, I know a few cars have this feature, I wasnt sure if they used it fo this motor,truck combo.
I will try it , if not I guess pulling plugs will have to do.
Ill try this, I know a few cars have this feature, I wasnt sure if they used it fo this motor,truck combo.
I will try it , if not I guess pulling plugs will have to do.
Automotive Network, Inc., Copyright ©2024