My instrument panel went completely dead today after pulling a rental trailer. Also the blinkers and stop lights. I can't seem to find the bad fuse. Would this be the self resetting fuses refered to in the manual, serviceable only by a dealer? thanks

Did this trailer just have a plug you hooked up to or did you or someone have to experiment around hooking wires up to make the trailer lights work?

Just plugged it into the flat plug, I have emailed chrysler and haven't got a response yet. All the trailer lights worked fine when I left the rental place. I did drive about 5 miles on a rough dirt road. thanks

I assume it is still under warranty. If so I would let the dealer sort it out. If not under warranty, I would start by turning the ignition and everything else off, then disconnect the battery neg. terminal for a few minutes. Then hook it back up. See if there is improvement.
Just curious, was everything off when you disconnected the trailer like ignition, lights?

It went dead before I disconnected it. I noticed it when I was driving down the dirt road.