Looking for an alternate method a forum member has used to successfully remove the passenger side inner CV joint/axle shaft from their 3.8 GT. I'm trying to skirt around :evillol: having to to go out and buy an equivalent GM J-33008 axle shaft remover and the slide hammer to pull it from the transmission; tools that would rarely be used by me. Any advice would be appreciated! :ylsuper:

Best not to waste any money on the special tools. Using a crowbar or pry bar, pry carefully and gently between the final drive housing and the surface of the inner cv joint. The axle shaft should pop out. Also, have a pan under there to catch the tranny fluid.

you can also check with Autozone parts stores, they lend specialized tools fo no charge as long as you bring them back intact.

you can also check with Autozone parts stores, they lend specialized tools fo no charge as long as you bring them back intact.

Not exactly free initially. You have to post a security deposit first last time I checked. When tool is returned and in same condition before loaned out then you will get your money back. :2cents: