just wanted to find out be comparrison if there was something wrong with my 2000 alero 3.4. at about 40-45 it almost seems like i "lose" alittle power and my rpms are running at 1200, at 60 i'm running at just a hair over 2k. is this normal or alittle off? whats do your 3.4's rev at when driveing at these speeds?

thanx all

l8rs

That sounds about right. At around 40-45 mph it will shift automatically to 4th gear - overdrive and on top of that the torque convertor clutch (TCC) locks up which will drop rpms by a few hundred which is for fuel economy.

just wanted to find out be comparrison if there was something wrong with my 2000 alero 3.4. at about 40-45 it almost seems like i "lose" alittle power and my rpms are running at 1200, at 60 i'm running at just a hair over 2k. is this normal or alittle off? whats do your 3.4's rev at when driveing at these speeds?

thanx all

l8rs

they have a 3.24 ratio so around 70 it should be like 2200 60 right below 2k or around it 1200 rpm sounds right for 40 mph mine is like a little above 1k and between 1250

hehe alright thanx guys. for as long as i've owned this car i guess i never really pay any attention to the rpms at steady speeds before, i drive it for 10+ hours a night but never at 1 specific speed for more then about a minute.
guess its running ok for once lol.

now to figure out which of the new wheel speed sensors is pissing me off,

l8rs

they have a 3.24 ratio so around 70 it should be like 2200 60 right below 2k or around it 1200 rpm sounds right for 40 mph mine is like a little above 1k and between 1250

How did you determine you have a 3.24:1 final drive ratio? :confused:

I have the 3.05:1 ratio which is GM RPO code F83.

How did you determine you have a 3.24:1 final drive ratio? :confused:

I have the 3.05:1 ratio which is GM RPO code F83.

well if it is the 4t45e MN5 trans it has 3.05 ratio