Our Community is 940,000 Strong. Join Us.


2000 Century Thermostat


jwichman
12-04-2006, 02:37 PM
Where did they hide the thermostat on the 2000 Century's? I cannot find it as shown in my Chilton's manual.

How big of a job is it to replace the thermostat?
Thanks,

BNaylor
12-04-2006, 04:38 PM
Just follow the upper radiator hose to where it terminates at the lower intake manifold below the throttle body. You'll see the thermostat housing. PITA to replace.

jwichman
12-10-2006, 08:37 AM
Is it neccessary to remove the heat sheild and exhaust crossover pipe to replace the thermostat, or can it be done with these in place? Also is there a gasket that needs to be replaced?

Thanks,

BNaylor
12-10-2006, 09:31 AM
It depends on the size of your hand and arms whether you will need to remove the heat shield and exhaust crossover pipe. Using the right sized tools helps too. As a minimum removing the heat shield may help. The thermostat housing bolts are not that long. Some people even remove the throttle body but that is up to you. There should be an o-ring seal. Good luck.

Add your comment to this topic!