I just got a 97 blazer and the pin that the top hinge on the drivers door seems to have worn through the bushing for it in the hinge. It allows the door to be just a bit further out than it should be so it does not seal as tight in the front as it should, and it leaks. I'm pretty sure the hinge is the problem (I have already replaced both the door and drip rail seal).

Anyone know if those bushings can be replaced? or the hinges (they look to be welded on) or something??

here is a pic of it:
http://www.1bad69.com/gallery/blazer/dcp02356.jpg

I got a new pin and 2 new bushings.... all is well now.

Use this link below. It gives you step by step instructions on replacement.
http://www.automotiveforums.com/vbulletin/showthread.php?t=476619&highlight=door+pins

Use this link below. It gives you step by step instructions on replacement.
http://www.automotiveforums.com/vbulletin/showthread.php?t=476619&highlight=door+pins


I think that you're a little late..... his second post said that he fixed it..... and it was 3 years ago. :iceslolan

I think that you're a little late..... his second post said that he fixed it..... and it was 3 years ago. :iceslolan

:lol:

Atta boy Gabe, better late than never right?! :D

I forgot my glasses. At the bar last night. (SHOOT GLASSES). :smokin:

I forgot my glasses. At the bar last night. (SHOOT GLASSES). :smokin:


SHOT GLASSES :lol2: :lol2: :lol2: :lol2: :lol2:

yep, got it taken care of.... Replacing the hinge bushing fixed the watter leak at the top front of the door.