Hey guys, I finally had time to finish the engine replacement on my 98 2 door 4wd Blazer. I broke off a couple of the bolts going to the Y pipe from the cat when I disassembled it. I tried to get the cat out, but it seems like there isn't enough room to remove it. Only had a couple minutes to try.. was wondering if anyone had any tips before I try again tommarow?... thanks

One more thing... I did remove the Oxy sensor that seemed to be in the way a little and still didn't seem like it wanted to come out, any help would be greatly appreciated

get the biggest hammer you have and start beating it out

get the biggest hammer you have and start beating it out

...worked for me. its sucky laying under there swinging away