I have a 1990 Accord and was going to upgrade to a cold air intake (I have a Short Ram now) And I was looking at my car today, and could not figure out how the tube gets down into my wheel well. I just got done instaklling a CAI on my friends 1999 Civic Si and There was a hole from the stock intake for the new intake to go into. I dont have anything like that on my car! How would I install a Cold Air intake? Would I have to do some drilling? I have an APC short ram with K&N Filter now, would I be better off getting an AEM intake if I was to stick with the Short ram or does it not make any differance? Thanks!

so long as you can get the filter down into the wheel well, you should be fine. I personally would not switch one short ram with another... just go for a CAI, it's much better. My advice would be to get the bumper off and look for the place where your stock airbox was and see if you cant make a hole for the CAI to go down into.

I wouldn't put an intake on my car dude, go read some tech at purehonda.org :)

Originally posted by sweetcarz.com
I wouldn't put an intake on my car dude, go read some tech at purehonda.org :)
whats bad about having an intake? do you have a link to a certain post?
and btw, your profile says you have an aem intake, y if its bad?