:uhoh: Help! Need diagram or picture of how to set timing on 1993 626 DOHC 4cyl 2.0 engine. Replaced timing belt, replaced water pump. Timing was knocked off. Turn crankshaft to TDC, set camshaft no.1 to no.1 on distributor. lined no.2 camshaft equally to no.1 where marks are aligned with cyl head. Put timing belt back on. Marks still on point. Rotated 2X by hand the crankshaft to see if any binding. NONE. Turned over engine. Everything rotated properly but no start. It would be a blessing to find out did I do everything right. Question. no.1 camshaft sproket has 3 marks. A dot, a mark in front of an I and one in front of a E. On both sprokets. Now what do I do? :banghead: