Our Community is 940,000 Strong. Join Us.


4x4 belltech s10 lowering kit question


crazycory1
02-23-2005, 01:28 PM
I bought a new but opened s10 (83-94) 4x4 belltech lowering kit on ebay. It did not come with the bump stops. Is anyone on here using this kit or has this kit but not installed it yet? Can you measure the bump stops for me so I can get the right ones. Thanks, Cory

rlith
02-24-2005, 05:40 AM
Most people cut the bumpstops off when they lower. Though for better lowering info go to www.blazinlow.com

crazycory1
03-29-2005, 01:37 PM
I found the part numbers for the bump stops, on the back of the instructions. Go figure. I was able to get them through partsamerica.com. Just thought I would pass the info along.

perfect10trucks
02-09-2006, 05:56 PM
i have 20" rims on my 4x4 and i was wondering if anyone knows if i would have alot of issues doing the torsion bar trick with these rims.trimming and a little cutting would not be a problem.

OverBoardProject
02-09-2006, 06:37 PM
Welcome to AF, perfect10trucks!
The only torsion bar trick that I would do with my trucks is raise it back to origional height if it sagged.
And then get a wheel alignment.

Otherwise you'll have increased tire wear and a poor handling ride.

Add your comment to this topic!