I bought a cheesey one from AutoZone that wasnt at all molded, and returned it. Whats the best made molded one that looks best on our Blazers?
Anyone got one that looks nice? Who makes it? Whats the P/N?

AVS has a good one.

Check ebay, very cheap and you can see how they look.

better then a GTS omni-shield?

Have a look.

Mine has a rasied ridge on the back edge.

Check out my cardomain page.

very nice. how much was it?
theres none on ebay right now.

Also, who made your side steps?? How much did you pay for them and where from? Are they a bitch to install?

http://search-desc.ebay.com/blazer-bug-deflector_Exterior_W0QQsofocusZbsQQsbrftogZ1QQcatr efZC12QQfromZR10QQsacatZ33637QQcatrefZC6QQftsZ2QQf trtZ1QQftrvZ1QQsadisZ200QQfsopZ1QQfsooZ1QQcoaction ZcompareQQcopagenumZ1QQcoentrypageZsearch

Running boards were stock from the factory.

I want the running boards like those most of all. Expensive though

I want the running boards like those most of all. Expensive though

Problem with running boards is all the debri that gets caught between the board and the rocker panels. The paint ends up scratching and then the rust starts..You're better off with a set of nerf bars.

Problem with running boards is all the debri that gets caught between the board and the rocker panels. The paint ends up scratching and then the rust starts..You're better off with a set of nerf bars.

No debris here. They protect the sides perfectly and stop a lot of the salt and sand from hitting under the door.

I also have molded mudflaps installed.

With running boards, I like how they hide the fram which does show signs of surface rust even if you undercoat the chassis constantly.