After I installed the new motor & tranny I am trying to get the car running fairly decent. The check engine light is ON so I know I do have some clean up work here. I have reset my TPS ICM numerous times and even swapped it out with a spare. This will continute to adjust itself up to 5 times before and after I turn the key on and off. Then when I think it set I start the car the idle is at 1500 RPM and IDLE will sail up 2 3000-3500 when I hit the gas and let off. Then when I shut the car off the ICM will again start adjusting itself with the key on then off etc for a few more times. I have unhooked the battery etc to reset the PCM but I am running out of ideas? Can anybody point me in the right direction. Thanks in advance for anyhelp you can give me.

TPS clean along with the throttle body?

TPS clean along with the throttle body?


Yes actually I have cleaned the TB twice with a tooth brush. I am thinking I might have a bad computer?

remann have you been to www.caddyinfo.com.

There are a lot of Northstar gurus over there man.