Washer pump motor
|
|
| Register and join the discussion |
Washer pump motor
steveb_92rodeo 02-08-2005, 12:42 PM '02 Civic, 4dr, 5spd, 1.7L Hi all, this is my first time posting in this forum. My girlfriends car is the above. Last year, I was parked at a store, and I swung the car around to pull out of the lot and a stop sign that was beside the car jumped out at me and smashed up the front left fender, as well as broke the washer pump motor. I replaced the motor and fender last year, but through the winter, on very cold days (-15 celcius) the pump will not push water. (READ: the pump won't even turn on). Once it warms up, the motor works fine. Now, when I replaced the fender, it appeared that the entire fender had to be removed to get to the washer tank. Is there an access cover anywhere that I can get at it and check this out without having to remove the fender again? Tks for any advice. Steve whtteg 02-08-2005, 04:24 PM -15 C what does that convert to in F? Is it below 32F? If so then maybe the washer fluid is freezing. steveb_92rodeo 02-08-2005, 04:29 PM -15 C what does that convert to in F? Is it below 32F? If so then maybe the washer fluid is freezing. Indeed 0 C is 32F, so this is well below 32F. I buy -40 degree washer fluid, and to prove this theory incorrect, I ran the tank dry (with a handheld electric pump), and put the same fluid in it that I run in my truck. My truck pump works in the cold, but the car does not...remember, same fluid. Thanks for the idea though, it is certainly a good one. I'm thinking a bad contact with the connector, mosture possibly freezing on the cold days, separating the contact from the motor itself. However, I don't want to have to take the fender off just to check that! Tks, Steve lorunner 02-08-2005, 09:52 PM No no access just remove the inner liner it sure is easier than the fender. And i agree that its without a doubt frozen fluid. steveb_92rodeo 02-09-2005, 08:33 AM No no access just remove the inner liner it sure is easier than the fender. Tks, I'll have a look on the weekend. And i agree that its without a doubt frozen fluid. I hate to disagree, but I have put the SAME FLUID in the car as I have in my truck, and tested with the same properties: - first thing on a cold morning - before both vehicles have been started - try both pumps, the truck works, the car does NOT Both vehicles are sheltered relatively the same amount from the wind. I don't understand it...considering there may be other variables involved, such as tank size etc, I haven't heard of anyones windshield anti-freeze freezing before. I'll have a look...if I'm wrong, I'll eat my shoe :) Thanks again! Steve AutomotiveHelper.com, Copyright ©2013
|