hesitation in engine/cold air intake installation
|
|
hesitation in engine/cold air intake installation shiftanfly 01-27-2005, 11:06 PM
ok im drivin a '97 golf 4 door 2.0 sapositly durin my 30 warrenty the dealership fixed this hesitation..or missfire in cylinder 3... an like 3 days after it was up it started missfireing again...any ideas as what i should do to fix this problem my self? also i've purchased a cold air intake...i've been waiting for time off from work to install it yet no directions came with the intake...its prolly a brainless thing to do..however its my first upgrade to any vehicle i've owned...so suggestions are welcome.. boschmann 01-28-2005, 03:33 PM Is it still only missing on #3, a dead miss at idle or a random sputter? Run by Autozone or Advance Auto & have them scan it (usually for free) to be sure it's not a random or multiple cylinder misfire. If it's only #3 then see what the dealer did & go from there. It could only be plug wire, cap, injector or low compression. shiftanfly 01-29-2005, 01:57 PM ^^^dealer is goin to fix thee problem free of charge due to the problem still being under warranty an not being fixed..now on to the intake thing Related Links Enter the largest automotive community on the planet! |