|
|
engine light on "95 contour????ekmarsal 11-13-2004, 09:49 PM Hi.I got this engine light on.AutoZone cannot check it because it's '95 model.Any idea how to get the codes out.Thanks beyondloadedSE 11-14-2004, 08:04 PM count the flashes. ekmarsal 11-17-2004, 05:00 PM Yeah. but it's not flashing ,it's on all the time. beyondloadedSE 11-17-2004, 10:05 PM hmm, i dont know what to tell ya. The only way to distinguish cel's in a obd-1 vehicle is to count the flashes and look up the code according to that. ekmarsal 11-19-2004, 12:12 AM Well, I'm thinking it must be air mass sensor,because the car is kind of jerky when I just start going in thr first gear 'till I gas it up a bit.Either that or fuel filter, I'm not sure.Thanks for the reply. emilgevor 12-01-2004, 05:39 PM Hey there. yeah i have the same problem with my ford. the light is on and my car jerks a little on the first gear. its automatic by the way. As i was told by some people that there could be few problems. one----O2 sensor two----air mass leak three--sensor on the air tube went bad I used the computer that i hooked up to my car and it told me P0171 system too lean(bank 1) if anyone know what that means please reply or send me email Emilgevor@yahoo.com thank you beyondloadedSE 12-01-2004, 05:44 PM Hey there. yeah i have the same problem with my ford. the light is on and my car jerks a little on the first gear. its automatic by the way. As i was told by some people that there could be few problems. one----O2 sensor two----air mass leak three--sensor on the air tube went bad I used the computer that i hooked up to my car and it told me P0171 system too lean(bank 1) if anyone know what that means please reply or send me email Emilgevor@yahoo.com thank you it means your rear bank is running lean. (more air than fuel). Id check for air leaks, clean the maf sensor, etc. emilgevor 12-01-2004, 05:46 PM is the MAF sensor located on the air tube right by the air intake? beyondloadedSE 12-01-2004, 05:52 PM is the MAF sensor located on the air tube right by the air intake? im not sure if your thinking about the IAT sensor. Here is just a generic picture of a MAF i found on ebay. http://i13.ebayimg.com/02/i/02/e3/86/8e_12_sb.JPG Heres a how to on how to clean the MAF. http://www.contour.org/mods/mods.php?s=howto&displayid=36 BAwebfoot 08-25-2007, 12:34 PM Autozone does not have the connection for a 1995 Contour ( under the hood ) but Schucks Auto does beyondloadedSE 08-27-2007, 10:46 AM Autozone does not have the connection for a 1995 Contour ( under the hood ) but Schucks Auto does Like I said in your other post. OBD-I does not have a connection. You count the flashes. Btw, thanks for reviving a 3 year old post. vBulletin®, Copyright ©2009, Jelsoft Enterprises Ltd.
Automotive Network, Inc., Copyright ©2009
|