blowing
lake films
07-26-2004, 04:42 PM
Hey everyone,
I hope someone can answer my question/problem:
My blower doesn't work on speeds 1-3, but works on 4. Here's what happened, one time I got in, it was blazing hot so I turned the air conditioner on and put the fan right to high. It then went dead, and decided to come back on in about 15 mins. Last week, I shut the van off to go into a store, but forgot to turn the air off and the blower was on either 2 or 3. Well, it hasn't worked since. I replaced the fuse, no dice. Looked under the hood, tapped the fan, still nothing. Actually, I'm not even sure where the blower is! Thanks in advance!
Hot in NY,
Lance :disappoin
I hope someone can answer my question/problem:
My blower doesn't work on speeds 1-3, but works on 4. Here's what happened, one time I got in, it was blazing hot so I turned the air conditioner on and put the fan right to high. It then went dead, and decided to come back on in about 15 mins. Last week, I shut the van off to go into a store, but forgot to turn the air off and the blower was on either 2 or 3. Well, it hasn't worked since. I replaced the fuse, no dice. Looked under the hood, tapped the fan, still nothing. Actually, I'm not even sure where the blower is! Thanks in advance!
Hot in NY,
Lance :disappoin
ol yeller
07-27-2004, 06:07 PM
The brushes are shot. Motors at Auto Zone run about 15 to 30. I believe mine is on the firewall pass side. 3 to sis screws.
Tonyd123
04-11-2005, 09:34 PM
I had the same problem on my ram van 2500. I replace the blower resistor, a dealer only item for $20. Mine was under the hood, left side, mounted in the heater duct work. You'll see two screws and two wires. What a sucky design by Dodge.
Automotive Network, Inc., Copyright ©2024