headlights
jedi 1
07-05-2004, 11:48 AM
Can anyone help me in how to remove the headlamp cover on a 1995 geo metro lsi i need to replace the signal light i removed the screws but the light will not move is there another screw that i am overlooking i would appreciate any help on the matter thank you very much.
Anthony Tigner
Anthony Tigner
mik13usa
07-11-2004, 01:06 AM
Anthony,
Coupe or 4 door? If I remember the signal or corner marker lamp is held in by only 2 screws sometimes the gasket gets a little sticky.
Good luck!
Coupe or 4 door? If I remember the signal or corner marker lamp is held in by only 2 screws sometimes the gasket gets a little sticky.
Good luck!
mcalvo
07-14-2004, 10:44 AM
Jedi:
My experiencie with the framed lights (non LSI models using regular square Hallogens) you have to take the from off removing two screws: one in the top of the frame, close to the corner lamp and a second one in the opposite corner. After that, you have to pull the whole thing towards to you because it has several clip guides.
Hope this would help you.
Regards,
MC.
My experiencie with the framed lights (non LSI models using regular square Hallogens) you have to take the from off removing two screws: one in the top of the frame, close to the corner lamp and a second one in the opposite corner. After that, you have to pull the whole thing towards to you because it has several clip guides.
Hope this would help you.
Regards,
MC.
Automotive Network, Inc., Copyright ©2024