Can anyone can give me info on replacing a ripped Outer CV Boot - I would really appreciate it. Any diagrams or places on the net I can get pics and or a process of how to do it, what tools I need, etc. would be super.

Thanks,

NicB.

What year and engine?

You will need
Breaker bar
30mm socket
14mm socket
17mm socket
10 mm socket
Pry bar
Cv boot pliers
snap ring pliers
dikes

1- remove the cotter pin and the nut at the end of the axle
2-remove the 14 nut from the sway bar link where it attaches to the strut.
3- remove 10mm bolt that holds the abs wire on the inner fender( this will allow you to move the strut out without breaking the wire.
4- remove the 2 17mm nuts and 1 bolt underneath the lower control arm.
5-Pry on the end of the lower control arm ans separate the control arm from the strut.
6- pry the inside of the cv axle out of the transaxle
7- remove the rings that hold in the inner boot first
8- once you get the inner boot off you will see a snap ring on top of the y shaped thing remove it.
9- remove the y shaped thing by tapping ouwards with a small hammer.
10- remove the outer boot
11-Install new boots in reverse order
Good Luck