Can anyone tell me the procedure for reseting the ECU on a 2.0 injection pinto powerd car.
Thge ecu is the EEC-IV.
Also can anyone please tell me the timing mark to use on the bottom pully for the smae engine 2.0 injection granada pinto engin i only have a manual for the 2.0 standerd pinto non injection and that says 4 degrees but is it the same for the injection.

THANKS in advance

normally if you take the negative battery terminal off for about 15 seconds that will reset the computer

yep,ditto that-if you want timing set up data sent please email me with engine code,i.e,ne4-nel-nra/nri,assume this is 85 to 89?

i can't remember where i heard this from, but you can check your codes with a simple volt meter by watching how many strokes the needle makes, i can't remember where you're supposed to hook it up though :/