ABS Diagnostic Error Codes (how to flash codes)
Spinman
02-17-2004, 10:00 PM
Researching the ABS system on ALLDATA, I found the following:
"The EBCM can display diagnostic trouble codes only when the 'Diagnostic Service Mode' has been entered. There are two ways to enter the diagnostic service mode: using a TECH1 scan tool or observing Anti-Lock warning lamp flash codes.The use of a TECH1 scan tool is recommended for diagnosing ABS faults."
1) How do you set the system up to display codes via the warning lamp flash? I was unable to find any information to accomplish this.
"The EBCM can display diagnostic trouble codes only when the 'Diagnostic Service Mode' has been entered. There are two ways to enter the diagnostic service mode: using a TECH1 scan tool or observing Anti-Lock warning lamp flash codes.The use of a TECH1 scan tool is recommended for diagnosing ABS faults."
1) How do you set the system up to display codes via the warning lamp flash? I was unable to find any information to accomplish this.
KillerKeller_jr
02-18-2004, 12:15 AM
Listed in a previous thread and I asked it. You can not display the codes via the warning lamp flash. The only way to pull the codes off the Aurora is a scan tool. Sorry to disapoint you.
Automotive Network, Inc., Copyright ©2024