starter
mpritch
02-09-2004, 10:52 AM
how do u change the starter and where is it?
Indy8
02-09-2004, 11:08 AM
Under the intake manifold. Fairly involved job for most people.
Marc_Aurora_2001
02-09-2004, 02:53 PM
Another forum had a discussion about this. Someone there said that
it took him a few days to do this job.
______________
GM!!! SAVE OLDS!!!
it took him a few days to do this job.
______________
GM!!! SAVE OLDS!!!
gates455cutlass
02-12-2004, 02:45 PM
I changed mine in about an hour and a half...I liked it better than going under the car like my 70 455.
kentuckyjoe
03-01-2004, 02:29 PM
My starter went ka-put too.
Finally got my nerve up to change it, it was not a bad job, but come to find out, the end of the starter were the out side bearing is housed, completely broke off, I mean the complete nose was laying on top of the flywheel, it was still in one big piece. Is this normal?
Finally got my nerve up to change it, it was not a bad job, but come to find out, the end of the starter were the out side bearing is housed, completely broke off, I mean the complete nose was laying on top of the flywheel, it was still in one big piece. Is this normal?
Indy8
03-02-2004, 01:07 PM
For American cars, yes.
jjdewd
03-02-2004, 02:01 PM
hmmm noone told mpritch how to change it lol! I haven't done mine so I can't help
Indy8
03-02-2004, 02:21 PM
Someone did describe the procedure in a previous post.
Automotive Network, Inc., Copyright ©2024