2001 Intrigue Keyless Remote
tbond75
02-08-2004, 04:02 PM
I am looking for programming instructions for my keyless remote. I bought one on eBay and was promised instructions with it. Guess what... I would appreciate any help in locating the instructions. Thanks in advance!
illinoiswronski
02-09-2004, 12:16 AM
search the archives, they are already in here somewhere.
tbond75
02-09-2004, 08:09 AM
I found one for the 1998 model, but it didn't work for the 2001. I'll look again to see if I overlooked it.
aljfoster
03-05-2004, 03:42 PM
If you find the instructions for the 2001 Intrigue let me know.
tbond75
03-05-2004, 04:22 PM
If you find the instructions for the 2001 Intrigue let me know.
Will do, but I am not confident. I have been looking for over a month.
Will do, but I am not confident. I have been looking for over a month.
wfreeth
07-05-2004, 09:43 PM
This one works for the 2001 Intrigue, I just tried it on 07/05/04 with the origanal remote and my recent eBay purchase.
1) Close all the vehicle doors.
2) Remove the ignition key from the ignition lock cylinder.
Important
In order to successfully enter the keyless entry programming/diagnostic mode, you must complete steps 4-6 within 25 seconds of pressing the door unlock switch.
3) Press and hold the door unlock switch.
4) While holding the door lock switch in the unlock position, Insert and remove the ignition key twice. Do not rotate the ignition lock cylinder.
Insert the ignition key a third time leaving the key in the ignition lock cylinder. Keep the ignition in the LOCK position for the rest of the procedure.
5) Release the door lock switch. The chime will sound 3 chimes, which signals that the transmitter programming/diagnostic mode is active.
6) Press and hold the lock and unlock buttons at the same time on the keyless entry transmitter for approximately 4 seconds. The chime will sound two times which signals that the transmitter has been programmed successfully.
Repeat step 6 for each of the four transmitters. including the origanal one.
7) Perform either of the following final procedures:
Turn the ignition switch to the RUN position.
Remove the ignition key from the ignition switch
1) Close all the vehicle doors.
2) Remove the ignition key from the ignition lock cylinder.
Important
In order to successfully enter the keyless entry programming/diagnostic mode, you must complete steps 4-6 within 25 seconds of pressing the door unlock switch.
3) Press and hold the door unlock switch.
4) While holding the door lock switch in the unlock position, Insert and remove the ignition key twice. Do not rotate the ignition lock cylinder.
Insert the ignition key a third time leaving the key in the ignition lock cylinder. Keep the ignition in the LOCK position for the rest of the procedure.
5) Release the door lock switch. The chime will sound 3 chimes, which signals that the transmitter programming/diagnostic mode is active.
6) Press and hold the lock and unlock buttons at the same time on the keyless entry transmitter for approximately 4 seconds. The chime will sound two times which signals that the transmitter has been programmed successfully.
Repeat step 6 for each of the four transmitters. including the origanal one.
7) Perform either of the following final procedures:
Turn the ignition switch to the RUN position.
Remove the ignition key from the ignition switch
paulkramer
07-07-2004, 10:20 AM
Ever heard of an Owner's Manual??
Automotive Network, Inc., Copyright ©2024